A 90° crank is a typical crank but with two kinks. In a 90° crank the top member will be horizontal and the bottom vertical. Cranked beams are most frequently used to support roof structures, therefore the angle of the middle member needs to follow the pitch of the roof. It is crucial that full penetration welds are used with these connections to ensure the crank will carry the load.
Crank 90°
£0.00
Related products
-
End Plate Connection
Select options This product has multiple variants. The options may be chosen on the product page £0.00 -
Base Plate
Select options This product has multiple variants. The options may be chosen on the product page £0.00 -
FLT Steel – Flat Section
Select options This product has multiple variants. The options may be chosen on the product page £0.00 -
Stiffener
Select options This product has multiple variants. The options may be chosen on the product page £0.00
Featured Products
-
Steel Rebar / Reinforcing Steel Bar
£0.00
-
Concrete Reinforcing Steel Mesh
£0.00
-
Gallow Bracket
£0.00